ConsecutiveCountInt

Overview

Counts repeated input values

Discussion

This module checks for repeated input samples from a single channel. The instance variable .value is set to the last input sample value. The instance variable .count is set to the number of consecutive times that the input signal was equal to .value. If the last two input samples are not equal, then .count equals 1.

The argument OUTPUTVALUE to the instantiation function specifies whether the module has any output pins. By default, OUTPUTVALUE=0 and the results of the computation are only stored to the instance variables. If OUTPUTVALUE=1, then the module has two output pins, named .value and .count, containing the respective values of the instance variables.

When bypassed and OUTPUTVALUE=1, the module always outputs the last input sample on pin .value and sets pin .count to 1. When muted and OUTPUTVALUE=1, the module always outputs zero on pin .value and sets pin .count to 0.

Module Pack

Advanced

ClassID

classID = 1242

Type Definition

typedef struct _ModuleConsecutiveCountInt
{
ModuleInstanceDescriptor instance;            // Common Audio Weaver module instance structure
INT32 value;                                  // Equals the last input sample
UINT32 count;                                 // Number of consecutive times that the last input sample was seen
} ModuleConsecutiveCountIntClass;

Variables

Properties

Name	Type	Usage	isHidden	Default Value	Range	Units
value	int	state	0	0	Unrestricted
count	uint	state	0	0	Unrestricted

Pins

Input Pins


Name	in
Description	Integer inputs
Data type	int
Channel range	1
Block size range	Unrestricted
Sample rate range	Unrestricted
Complex support	Real

Output Pins


Name	value
Description	Contains the instance variable .value
Data Type	int


Name	count
Description	Contains the instance variable .count
Data Type	int

Matlab Usage

File Name: consecutive_count_int_module.m 
 M=consecutive_count_int_module(NAME, OUTPUTVALUE) 
 Audio Weaver module that the number of consecutive input values 
 that are of the same value.  The module has two internal variables 
 that are of note: 
    .value - last input value to the module 
    .count - number of consecutive times that the input was equal to 
             .value.  If the input has just changed, then .count=1. 
    OUTPUTVALUE - specifies whether the module has an output pin. 
                  By default, OUTPUTVALUE=0 and the result of the 
                  computation is only stored to the instance variables 
                  If OUTPUTVALUE=1, then the module has two output pins 
                  named .value and .count 
 The module's input pin can only contain a single channel.